ADC SWD4573I1 Manuale Utente

You can configure several system-wide STP parameters. Each parameter comes preconfigured 
with a default value, however you can modify each setting.

You modify system STP parameters from the 

::globalstp=>

 prompt. From the 

::root=>

 prompt, type the following command then press 

 to display the 

::globalstp=>

 prompt.

From the 

::globalstp=>

 prompt, type the modify command in the following format, then 

press .

modify [-stpenable (on|off)] [-stppri <priority>][-maxage <sec>]

[-hellotime <sec>] [-fddelay <sec>]

[-stpenable (on|off)]

Enables or disables Spanning Tree Protocol. Type 

 to enable it. Type 

 to disable it.

[-stppri <priority>]

The priority of the system (the entire chassis) within the network. The valid range is 0 to 
65535. The value 0 indicates the highest priority. The default value is 32768.

[-maxage <sec>]

The number of seconds after which entries in the Bridging Table will be deleted if they are 
not re-learned. The valid range is 6 to 40. The default value is 20.

Bridging Enabled

Indicates whether system bridging is enabled or disabled.

WAN Broadcast Enabled

Indicates whether unknown WAN frames are broadcast to all 
logical interfaces.

Aging Time (sec)

Specifies the interval, in seconds, after which Bridging Table 
entries are deleted if they are not relearned.