ADC SWD4573I1 Manuale Utente

If you selected 

 in 

, in the 

 box type the number of seconds 

that you want the system to wait before switching traffic from the protection channel back 
to the working channel after a failure on the main channel has been cleared. Otherwise, skip 
this step.

The range is 300 to 720 seconds. The default is 300 seconds.

Do one of the following:

To activate the settings and close the 

 window, click 

 then in the 

confirmation dialog click 

.

Click 

to cancel the new settings. You can only cancel the new settings if you have 

not clicked 

.

Once APS is enabled, if the APS is currently set to either Non Revertive mode, you can override 
the configured APS operation by selecting one of the following APS commands. After issuing 
a manual APS command, you must issue a 

 command to resume the configured APS 

operation.

In the 

 box, select the desired manual APS command.

Clear—

clears any of the following manual commands. 

Lockout Protection—

disables APS.

Force to Protection—

switches traffic to the protection channel.

Force to Working—

switches traffic to the working channel.

To Working If Ready—

switches traffic to the working channel if there are not other 

conditions (such as the configured Wait To Revert Time or a failure condition) that 
prohibit switching to that channel.

Do one of the following:

To activate the settings and close the 

 window, click 

 then in the 

confirmation dialog click 

.

Click 

to cancel the new settings. You can only cancel the new settings if you have 

not clicked 

.