ADC SWD4573I1 Manuale Utente

Install a 

card in the line-side of the subtended system (see 
the table on 

) that is compatible with the 

card you selected in 

 above. For example, if you select a 

DS1 card for subtending, then use one of the 
following:

DS1 card in slot 3 of a subtended AV3000 
system

OC3 card in slot 2 of a subtended AV3000 
system

DSX-1 or OC3 card in slot 11 or 12 of a subtended AV8000 system

DS1 line/management card in slot 1 of a 2200

The line-side interface provides the network line interface to the subtending system.

Refer to the applicable Avidia 8000 and 8100 Installation Manual, Avidia 3000 and 8100 
Installation Manual, or Avidia 2200 Installation Manual for more information about installing 
systems and placement of cards.

Consider what traffic contract you need to set up for each connection and what policing, through 
the Usage Parameter Control (UPC), applies to the connection.The traffic contract and policing 
you select is dependent on the service you provide. The traffic contract and policing selection 
should maximize the network throughput and minimize end-to-end delays, thus efficiently 
utilizing the network. Complete the following sections to set up the connections for subtending.

Create ATM profiles, if required, for the service you will supply (see 

 (command-line interface) or 

 (Web interface) for more information). Remember that 

upstream and downstream rates and the QoS must be supported end-to-end.

Select a traffic type. See 

 for a list of available traffic types.

Select a value for traffic parameters to complete the traffic contract. See 

 for a list of 

traffic parameters available.

To

Subtending

Cards

Subtending System

ATM

Switch

Subtended System

Subtended System

12

PairGain

PairGain

12

PairGain

PairGain