Texas Instruments TMS320DM643X DMP Manuale Utente

Pagina di 120
www.ti.com
5.49.15 Broadcast Transmit Frames Register (TXBCASTFRAMES)
5.49.16 Multicast Transmit Frames Register (TXMCASTFRAMES)
5.49.17 Pause Transmit Frames Register (TXPAUSEFRAMES)
5.49.18 Deferred Transmit Frames Register (TXDEFERRED)
5.49.19 Transmit Collision Frames Register (TXCOLLISION)
Ethernet Media Access Controller (EMAC) Registers
The total number of good broadcast frames transmitted on the EMAC. A good broadcast frame is
defined as having all of the following:
Any data or MAC control frame destined for address FF-FF-FF-FF-FF-FFh only
Was of any length
Had no late or excessive collisions, no carrier loss, and no underrun
The total number of good multicast frames transmitted on the EMAC. A good multicast frame is defined
as having all of the following:
Any data or MAC control frame destined for any multicast address other than FF-FF-FF-FF-FF-FFh
Was of any length
Had no late or excessive collisions, no carrier loss, and no underrun
The total number of IEEE 802.3X pause frames transmitted by the EMAC. Pause frames cannot
underrun or contain a CRC error because they are created in the transmitting MAC, so these error
conditions have no effect on this statistic. Pause frames sent by software are not included in this count.
Since pause frames are only transmitted in full-duplex mode, carrier loss and collisions have no effect
on this statistic.
Transmitted pause frames are always 64-byte multicast frames so appear in the multicast transmit
frames register and 64 octect frames register statistics.
The total number of frames transmitted on the EMAC that first experienced deferment. Such a frame is
defined as having all of the following:
Was any data or MAC control frame destined for any unicast, broadcast, or multicast address
Was any size
Had no carrier loss and no underrun
Experienced no collisions before being successfully transmitted
Found the medium busy when transmission was first attempted, so had to wait.
CRC errors have no effect on this statistic.
The total number of times that the EMAC experienced a collision. Collisions occur under two
circumstances:
When a transmit data or MAC control frame has all of the following:
Was destined for any unicast, broadcast, or multicast address
Was any size
Had no carrier loss and no underrun
Experienced a collision. A jam sequence is sent for every non-late collision, so this statistic
increments on each occasion if a frame experiences multiple collisions (and increments on late
collisions).
When the EMAC is in half-duplex mode, flow control is active, and a frame reception begins.
CRC errors have no effect on this statistic.
112
Ethernet Media Access Controller (EMAC)/
SPRU941A – April 2007
Management Data Input/Output (MDIO)