Cisco Systems Cisco MGX 8850 Manuale Utente

5-41

Cisco MGX 8850 Routing Switch Command Reference

Release 2.0, Part Number 78-10467-04 Rev C0, October 2001

Chapter 5

PNNI Commands

cnfpnni-svcc-rcc-timer

Configure PNNI Switched Virtual Connection Routing Control Channel (SVCC-RCC) Timer—specify the parameters
for any PNNI RCCs between logical nodes.

The current release does not support this command. The cnfpnni-svcc-rcc-timer command lets you
specify the initial PNNI SVCC-based variables for a network node. Logical group nodes (LGNs) use
SVCC-RCCs to exchange routing information.

Cards on Which This Command Runs

PXM45

Syntax

cnfpnni-svcc-rcc-timer <node-index>

[-initTime init-time]

[-retryTime retry-time]

[-callingIntegrityTime calling-integrity-time]

[-calledIntegrityTime called-integrity-time]

Syntax Description

node-index

In the current release, the only supported value for node-index 1. The node
index indicates the relative level of the logical node within a multi-peer
group on the switch. The range is 1–10, and the lowest level is 1.

Range: 1–10
Default = 1

-initTime

The number of seconds this node waits before it advertises its choice of
preferred SVCC to a neighbor with a numerically lower ATM address. This
node does so after determining that such an SVCC should be established.

Range: 1–10 seconds
Default = 10

-retryTime

The number of seconds this node waits before it attempts to re-establish an
apparently necessary and viable SVCC-based RCC that was unexpectedly
torn down.

Range: 10–60 seconds
Default = 60