Q-Logic SANBOX2-64 Manuale Utente
6 – Removal/Replacement
Power Supply Modules
59043-01 A
6-17
Figure 6-7. Removing a Power Supply Module
6.5.2
Installing a Power Supply Module
To install a power supply module, do the following:
1.
Slide the power supply module into the slot guide until it contacts the
backplane.
backplane.
2.
Rotate the blade latch upward to lock the power supply module in place.
Fasten the screws.
Fasten the screws.
3.
Reconnect the power cord to the power supply module and confirm that the
Output Power LED illuminates.
Output Power LED illuminates.
4.
Confirm the power supply module status. Do one of the following:
■
Open a Telnet session and enter the Show Chassis command to
display the operational status of the power supply modules. Refer to
the
display the operational status of the power supply modules. Refer to
the
■
Observe the power supply status in the Switch data window of the
SANbox Manager topology display. Refer to the SANbox2-64 Switch
Management User’s Guide.
SANbox Manager topology display. Refer to the SANbox2-64 Switch
Management User’s Guide.
Release Button
Latch
Screw
Screw
Ground Jack