Netgear m6100 Manuale Utente

The default admin user name is admin and the default admin password is blank, that is, 
do not enter a password.

Disable the default DHCP client mode in order to assign an IP address manually. Enter one 

of the following commands:

For the network interface:

For the service port:

Set the IP address, subnet mask, and gateway address by entering one of the following 

commands:

For the network interface:

network parms ipaddress subnetmask [gateway]

For the service port:

serviceport parms ipaddress subnetmask [gateway]

Use the following information to configure the parameters:

ip address. The unique IP address for the switch. Each IP parameter is made up of 

four decimal numbers, ranging from 0 to 255.

subnetmask. The subnet mask for the LAN.

gateway. The gateway address for the subnet. No default subnet exists.

To enable these changes to be retained during a reset of the switch, type save at the main 

menu prompt, and type y to confirm the changes.

To view the changes and verify the IP address information, enter the show network or 

show service command.
The switch is now ready for Telnet and SSH access as well as for web-based 
management.

You can perform the initial configuration by using the Easy Setup Wizard (ezconfig) over the 
network interface, service port, or console port.

ezconfig is an interactive utility that provides a simplified procedure for setting up the 
following basic switch settings:

Switch management IP address

Switch admin user password

Switch name and location