LevelOne KVM-0407 Manuale Utente

 - 

13 - 

4. Switching KVM-0407 

KVM-0407 supports 3 methods to switch between computers: Push button, Hot 

Keys and OSD. Due to refresh of the video and re-synchronization of the mouse 

and keyboard signal, it will take 1-3 seconds configure time after each switching. 

This is the normal operation that ensures the proper synchronization is 

established.  

 

Note:  

The drivers for most USB devices (Mass Storage device, CCD Cameras, Scanners, 

Card Reader, Printers, e.g.) are required to be shut down or follow the “Safely 

Remove” command provided in Windows before you disconnect the device, or 

else the system might be hanged. When you switch computers with the Port 

Selection Switch, it is the equivalent of disconnecting the device. Therefore, if 

you have peripheral devices (other than a second keyboard and mouse) connected 

to these ports, you must be sure to shut down or safely remove the USB driver 

for them before switching computers. 

 

You can switch to any other available active USB host connection by simply push 

the appropriate switch button on KVM-0407. The LED will be lit to indicate 

which port is currently selected. 

 

You can switch to any available active USB host connection by using the three 

steps Hot Key directly, instead of manually select by pushbutton. To send 

commands to KVM-0407, 

  must be pressed twice ( Step1 ). Then you can 

press [1] to [4] (Step 2) to switch between ports. (Support PS/2 Keyboard only)