Gateway 920 Manuale Utente

Troubleshooting

www.gateway.com

■

Restart your server, then press and hold F2 to open the BIOS Setup utility. 
Make sure that the IDE controllers are enabled. For more information, see 

.

■

Reinstall the device driver. For more information, see 

.

■

Follow the instructions in the drive’s documentation to make sure that the 
drive is configured correctly.

■

Open your server case and make sure that the cables are connected 
correctly to the CD or DVD drive and the IDE connector on the system 
board or controller card.

■

Press a straightened paper clip wire into the CD or DVD drive’s manual 
eject hole. The drive tray opens.

■

If this problem happens frequently while the server is turned on, the drive 
may be defective.

■

Restart your server.

■

Open your server case and make sure that the cables are connected 
correctly to the diskette drive and the system board. The red-striped edge 
of the data ribbon cable indicates Pin 1 and corresponds with Pin 1 on the 
diskette drive (typically on the side farthest from the power supply 
connection). If necessary, reverse one end of the cable so the red-striped 
edge of the data ribbon cable faces Pin 1 on the diskette drive. Make sure 
that the pins are not bent or misaligned. For more information, see 

.

■

Remove the diskette from the drive. If the light stays on, try restarting your 
server.