Brocade Communications Systems DCX 8510-4 Manuale Utente

Brocade DCX 8510-4 chassis removal and replacement

5

The system is going down for system halt NOW !!

DANGER

2. Power off the chassis by flipping all AC power switches to the off position. (The power supply 

status LED should turn off.)

3. Remove the power cords from the power supplies and the power outlets.

4. Remove the chassis door.

5. Label the cables connected to all blades and record the connections.

6. Disconnect the cables from the SFP+ transceivers in the application and port blades and set 

them aside. If you have mSFP transceivers in FC8-64 port blades, remove the transceivers and 
cables together and set them aside. The SFP+ transceivers can be left in the port blades or 
removed.

7. Disconnect all cables from the control processor and core switchblades.

8. Disconnect any ICL or QSFP cables.

Removing components from the chassis

ATTENTION
Follow ESD precautions (

).

1. Remove the chassis door (

) if not already done.

2. Remove the cable management fingers (

3. Remove the port, application, and encryption blades or filler panels (

4. Remove the core switch blades (CR16-4) (

5. Remove the control processor blades (CP8) (

6. Remove the power supplies or filler panels (

7. Remove the blower assemblies (

8. Remove the WWN bezel (logo plate) and WWN cards (

Installing the replacement chassis

Complete the following steps to install the replacement chassis.