Pressure Systems 98RK Manuale Utente
Pressure Systems, Inc. 98RK-1 & 9816 User’s Manual©
Page 98
www.PressureSystems.com
RE-BOOT MODULE (UDP/IP Command 'psireboot')
Purpose: To unconditionally “reboot” a specified module.
Command
“psireboot ethadr”
where ethadr is the Ethernet Address of the specified module in the
following special hex-digit format ‘xx-xx-xx-xx-xx-xx’
where ethadr is the Ethernet Address of the specified module in the
following special hex-digit format ‘xx-xx-xx-xx-xx-xx’
Response
none (module reboots).
Description: When a NetScanner
™
System module receives this broadcast command (by
continuously monitoring port 7000) it responds by restarting its firmware
immediately. The result is essentially the same as a power up restart, in that any
TCP/IP connection is lost, and the module returns to its normal startup state.
The host must wait long enough for the reboot process to be completed before is
can again address the module.
immediately. The result is essentially the same as a power up restart, in that any
TCP/IP connection is lost, and the module returns to its normal startup state.
The host must wait long enough for the reboot process to be completed before is
can again address the module.
Example:
●
Reboot a specified module on then network.
"psireboot 12-34-56-78-90-12"
Response:
(None)
(None)