Grizzly T26417/T26418 Manuale Utente
Model T26417/T26418 (Mfd. Since 11/13)
-17-
Assembly
Place the spindle assemblies and table inserts
in the appropriate-sized accessory slots beneath
the table (see
in the appropriate-sized accessory slots beneath
the table (see
Figure 10). A sanding drum
assembly does not need to be installed until after
the test run.
the test run.
Figure 11. Dust port.
Dust Collection
To connect a dust collection hose:
1. Fit a 2" dust hose over dust port shown in
Figure 11, and secure in place with a hose
clamp.
clamp.
2. Tug hose to make sure it does not come off.
Note: A tight fit is necessary for proper per-
formance.
formance.
Recommended CFM at Dust Port: 200 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
This machine creates substantial amounts
of dust during operation. Breathing air-
borne dust on a regular basis can result in
permanent respiratory illness. Reduce your
risk by wearing a respirator and capturing
the dust with a dust collection system.
Dust Port
Figure 10. Table insert and spindle assembly
holder.
Table Insert
Holder
Spindle
Assembly
Holder