Grizzly T26417/T26418 Manuale Utente
-18-
Model T26417/T26418 (Mfd. Since 11/13)
Figure 12. Removing switch key from paddle
switch.
Test Run
5. Try to start machine by pressing switch but-
ton.
Machine should NOT start. If it does start,
the switch disabling feature is not functioning
properly and the switch must be replaced.
the switch disabling feature is not functioning
properly and the switch must be replaced.
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components function properly.
to ensure it is properly connected to power and
safety components function properly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly setup machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3. Turn machine ON. Verify motor operation,
and then turn machine
OFF.
The motor should run smoothly and without
unusual problems or noises.
unusual problems or noises.
4. Remove switch disabling key, as shown in
Figure 12.