Grizzly G0450 Manuale Utente

-20-

G0449/G0450 37" Drum Sander

Test Run

Now that the machine is connected to the power
source, it is important to perform a test run to
make sure all the controls are working properly.

Before starting the sander, make sure you

have performed the preceding assembly

and adjustment instructions, and you have

read through the rest of the manual and

are familiar with the various functions and

safety issues associated with this machine.

Failure to follow this warning could result in

serious personal injury or even death!

To test run the sander:

1. Put on safety glasses and make sure any

bystanders are out of the way and also wear-
ing safety glasses.

2. Rotate the red EMERGENCY STOP button

until it springs up.

3. Press the conveyor START button.

—If any problems occur, press the

EMERGENCY STOP button.

—For Model G0450 only: If the conveyor

belt is rotating backwards, disconnect the
sander from power and exchange wires L1
& L3 in the control panel.

4. Press the SANDING DRUMS START but-

ton.

—If any problems occur, press the

EMERGENCY STOP button.

Investigate and correct any problems before
operating the machine further. If you need help,
refer to the

Troubleshooting section in the back

of this manual or contact Tech Support at (570)
546-9663.

Recommended

Adjustments

For  your  convenience,  the  adjustments  listed
below  have  been  performed  at  the  factory  and
no  further  setup  is  required  to  operate  your
machine.

However, because of the many variables involved
with shipping, some of these adjustments may
need to be repeated to ensure optimum results.
Keep this in mind as you start to use your new
drum sander.

Step-by-step instructions for these adjust-

ments can be found in SECTION 7: SERVICE

ADJUSTMENTS.

1. V-Belt Service (Page 30). Perform after the

first 16 hours.

2. Conveyor Tensioning & Tracking (Page 32).

3. Drum Adjustments (Page 33).

4. Pressure Roller Height (Page 36).

5. Dust Scoop Position (Page 37).