Grizzly G1128 Manuale Utente

G1128/G1129 Power Feeders

-17-

The internal gearbox oil should be drained and
replaced after every 500 hours of operation. A
drain plug at the top of the wheel housing pro-
vides access for removal of old oil. Remove the
motor/wheel apparatus from the pivot joint,
remove the plug, tip over and drain. Be careful
not to get oil all over the motor. Re-fill to within 

1

⁄

2

"

of the filler plug with 80-90 weight gear oil.

Regular periodic maintenance on your Model
G1128/G1129 Power Feeder will ensure its opti-
mum performance. Make a habit of inspecting
your Power Feeder each time you use it. Check
for the following conditions and repair or replace
when necessary.

Loose mounting bolts.

Worn switch.

Worn or damaged cords and plugs.

Any other condition that could hamper the
safe operation of this machine.

Each of the three roller wheels is fitted with a
grease fitting. Lubricate after every 80 hours of
use. The G1129 comes with a grease gun. The
G1128 requires purchasing a grease gun from
your local hardware store.

Replace rollers when they become worn or dis-
figured. Rollers may be ordered through the
Grizzly parts department. Contact the appropriate
service department.

Clean the wheels when they become dirty. Use a
moist brush with light detergent. Do not allow dirty
wheels to leave unwanted marks on your work-
piece. 

Lubricate drive gears and chains with grease
after every 80 hours of operation. Clean and lubri-
cate all the machined surfaces with light machine
oil.