RedMax BC2200LDC Manuale Utente

■ HE2200LDC
1. Install the blade guard to the gear case with

the provided 3 screws.

2. Place the blade between the cutter holders

(A) and (B) while locking the gear shaft by
putting the bar , one of the tools provided,
through the key holes on the holder(A) and
the gearcase. Use the socket and the bar
as shown in the picture below to tighten the
mounting nut.

3. Install the J-shaped handle to the shaft tube

and clamp at a position best for your job.

• ADJUSTING HANDLE POSITION
Loosen the handle bracket screws and
reposition the handle to your best operating
position. Re-tighten the screws.

1. Install the driveshaft assembly to the engine

unit. Clamp it securely with the attached
bolt and nut.

2. Connect the throttle cable to the engine.

3. Mount the handle to the driveshaft casing

and clamp it at a position suitable for
operation.

4. Install the debris guard to the bracket with

screws provided.

Attach the guard above the clamp and slide
it down. Rotate it a half turn to set in place.

 3 