RedMax BC2200LDC Manuale Utente

The RedMax engines are lubricated by oil
specially formulated for air-cooled 2-cycle
gasoline engine use. When RedMax oil is not
available, use an anti-oxidant added quality oil
formulated for air-cooled 2-cycle engine use. 

Exhaust emission are controlled by the
fundamental engine parameters and
components (eq., carburation, ignition timing
and port timing) without addition of any major
hardware or the introduction of an inert
material during combustion. 
These engines are certified to operate on
unleaded gasoline. 

■ HOW TO MIX FUEL 
1. Mix the fuel and oil at 32 : 1

2. Put some of the gasoline into a clean,

approved fuel container. 

3. Pour in all of the oil and agitate well. 

4. Pour in the rest of gasoline and agitate

again for at least one minute. 

5. Put a clear indication on the outside of the

container to avoid mixing up with gasoline
or other containers. 

■ FUELING UNIT 
1. Untwist and remove the fuel cap. Rest the

cap on a dustless place. 

2. Put fuel into the fuel tank to 8O% of the full

capacity. 

3. Fasten the fuel cap securely and wipe up

any fuel spillage around the unit. 

1. Select bare ground for fueling. 

2. Move at least 10 feet (3 meters) away from

the fueling point before starting the engine. 

3. Stop the engine before refueling the unit. 

1. FUEL WITH NO OIL (RAW GASOLINE) —

It will cause severe damage to the system. 

2. GASOHOL — It can cause deterioration of

rubber and/or plastic parts and disruption of
engine lubrication. 

3. OIL FOR 4-CYCLE ENGINE USE or

WATER COOLED 2-CYCLE ENGINE USE
— It can cause spark plug fouling, exhaust
port blocking, or piston ring sticking. 

 4 