John Deere ET-3103-J Manuale Utente

Cordless Impact Wrench Operator's Manual

Assembly

REMOVAL AND INSTALLATION OF BATTERY:

How to install the battery:

Align the battery with the groove in tool handle and slip it

into place. Always insert it all the way until it locks in place

with a little click. If not, it may accidentally fall out of the

tool, causing injury to you or someone around you. (Fig. 3)

How to remove the battery:

Withdraw battery from the tool handle while pressing the

latch on the side of the battery. (Fig. 3)

CHARGING METHOD:

NOTE: Before plugging into the receptacle, make sure

of the following points. The power source voltage

is stated on the nameplate. The cord is not

damaged.

WARNING: DO NOT CHARGE AT VOLTAGE

HIGHER THAN INDICATED ON THE

NAMEPLATE. IF CHARGED AT

VOLTAGE HIGHER THAN

INDICATED ON THE NAMEPLATE,

THE CHARGER WILL BURN UP.

1. Insert the plug of battery charger into the receptacle.

When the plug of battery charger has been inserted

into the receptacle, pilot lamp will blink in red. (At 1-

second intervals)

WARNING: DO NOT USE THE ELECTRICAL

CORD IF DAMAGED. HAVE IT

REPAIRED IMMEDIATELY.

2. Insert the battery into the battery charger. Insert the

battery into the battery charger as shown in Fig. 4.

Make sure it contacts the bottom of the battery

charger.

CAUTION:

IF THE BATTERIES ARE INSERTED

IN THE REVERSE DIRECTION, NOT

ONLY RECHARGING WILL BECOME

IMPOSSIBLE, BUT IT MAY ALSO

CAUSE PROBLEMS IN THE

CHARGER SUCH AS A DEFORMED

RECHARGING TERMINAL.

(Fig. 3)

(Fig. 4)

Rechargeable

Battery

Pilot Lamp

Battery Installation

Hole