Chauvet LG-3355 Manuale Utente

 

Rear of fixture

Bottom of fixture

Voltage select 

Infrared sensor select 

1 

2 

3 

4 

6 

5

7

8

1) 

On/Off switch: Turn on/off the unit. 

2) 

Power cord: This connection supplies main power to the fixture. Be sure the main power 
matches the required power of your fixture. 

3) 

Fuse holder: This housing stores the protective fuse. Always replace with the extra same type 
fuse. Replacement with anything other than the specified part may damage your unit. 

4) 

Red LED: Power indicator, Blue LED: Sound indicator. 

5) 

Master/Slave Mode: Select the master/slaver mode.  

6) 

Signal input/output: uses a 3.5mm stereo microphone cable to link the unit together for 
master/slave link. 

7) 

AC voltage selector switch 

8) 

Infrared sensor (rear or front) selector switch 

Note: Maximum linking in Master/Slave mode is 8 fixtures. 

1) 

Turn Off all projectors. 

2) 

Connect up to 8 fixtures using a daisy chain method. From the signal output of the first projector 
to the signal input of the following projector and then repeat for the following projectors. 

3) 

Set the Master/Slave switch on the first unit in the daisy chain to Master and turn this projector 
ON before all other projectors. 
Important: Turn Master unit On First otherwise link will not be consistent.   

4) 

On all remaining units set the Master/Slave switch to Slave then turn those projectors on. 

LG-3355 User Manual 

6

 

11/14/2007/18:12