Chauvet LG-3355 사용자 설명서
Rear Panel Control Details
Back
Infrared
Infrared
Power On/Off
Sound
Back
Front
Infrared Switch
Rear of fixture
Bottom of fixture
Back
Front
Infrared Switch
Voltage select
Infrared sensor select
1
2
3
4
6
5
7
8
1)
On/Off switch: Turn on/off the unit.
2)
Power cord: This connection supplies main power to the fixture. Be sure the main power
matches the required power of your fixture.
matches the required power of your fixture.
3)
Fuse holder: This housing stores the protective fuse. Always replace with the extra same type
fuse. Replacement with anything other than the specified part may damage your unit.
fuse. Replacement with anything other than the specified part may damage your unit.
4)
Red LED: Power indicator, Blue LED: Sound indicator.
5)
Master/Slave Mode: Select the master/slaver mode.
6)
Signal input/output: uses a 3.5mm stereo microphone cable to link the unit together for
master/slave link.
master/slave link.
7)
AC voltage selector switch
8)
Infrared sensor (rear or front) selector switch
Master/Slave Operation
Note: Maximum linking in Master/Slave mode is 8 fixtures.
1)
Turn Off all projectors.
2)
Connect up to 8 fixtures using a daisy chain method. From the signal output of the first projector
to the signal input of the following projector and then repeat for the following projectors.
to the signal input of the following projector and then repeat for the following projectors.
3)
Set the Master/Slave switch on the first unit in the daisy chain to Master and turn this projector
ON before all other projectors.
Important: Turn Master unit On First otherwise link will not be consistent.
ON before all other projectors.
Important: Turn Master unit On First otherwise link will not be consistent.
4)
On all remaining units set the Master/Slave switch to Slave then turn those projectors on.
LG-3355 User Manual
6
11/14/2007/18:12