Bunn LCC-2 LP Manuale Utente

6

NOTE:  The LCC-2 LP weighs approximately 70 lbs. (32 kg).  If necessary, use more than one person when lifting 

or moving the dispenser.

1.  Cut the plastic bands and remove the top box.

2.  Locate and remove the parts box from top of packaging and set aside.

3.  Remove foam packing.

4.  Set dispenser on the counter where it is to be used.   CAUTION: DO NOT LIFT ON THE DOOR.

5.  Open the parts box remove the drip tray, brackets and splash guard.

6.  Install the drip tray assembly.

 

a.  Loosen the front two legs several turns.

 

b.  Slide the drip tray brackets between the large washers and the base plate.

 

c.  Retighten the two front legs securing the bracket.

 

d.  Install the drip tray.

CAUTION:  Improper electrical installation will damage electronic components.

1.  An electrician must provide electrical service as specified in conformance with all local, state and federal 

electrical codes.

2.  Using a voltmeter, check the voltage and color-coding of each conductor at the electrical source.

3.  Connect the dispenser to the power source.

4.  If plumbing is to be hooked up later, be sure the dispenser is disconnected from the power source.  If plumbing 

has been hooked up, the dispenser is ready for Initial Fill & Heat.

7.  Install the splash guard panel.

 

a.  Insert the top tabs into the slots on the door panel.

 

b.  Align the key hole slots over the two lower screws, then slide the 

splash guard down.

 

c.  Tighten the two lower screws.

8.  Level the dispenser using the adjustable feet on the legs.

1.  Securely attach the short piece of tubing and the water strainer assembly 

to the inlet fitting on the bottom of the dispenser.

2.  Flush the water line to remove any debris or foreign material, and 

securely attach it to the flare fitting on the water strainer assembly.

3.  Turn on the water supply and check for leaks.

39288 083106