Bunn MCP Manuale Utente

15

When disassembling your brewer for cleaning, inspect the sprayhead 

seal for cracks, tears and holes. Although the seal should last for an 

extended period of time, damage can occur through handling. 
CAUTION: The seal confines the hot liquid to the pod holder. Replace the 

To prevent residue build up, it is a good idea to periodically disassemble 

the pod holder/screen assembly and clean it with a 

mild detergent.

1)  Press and hold the POD RELEASE BUTTON while 

sliding the pod holder out.

2)  Flip the POD HOLDER upside down and place the 

holder cavity over the palm of your hand.

3)  Using a small object, press the tab of the POD 

HOLDER INSERT through the hole in the bottom of 

the pod holder to remove.

4)  Clean the screen and holder using a mild detergent and rinse. 

(Dishwasher Safe)

5)  Press the insert back through the hole in the bottom of the POD 

HOLDER.

If the brewer has not been used for an extended period of time, it is a 

good idea to cycle your brewer before brewing a cup of coffee or tea.

1)  Remove the reservoir and pod holder from the brewer, clean with a 

mild detergent and rinse.

2)  Refill the reservoir to the maximum line.

3)  Insert an empty pod holder into the brewer.

4)  Set the volume control lever to the maximum setting.

5)  Place a bowl or cup on the drip tray grate that will hold at least 14 oz.

6)  Press the coffee brew button.

7)  When the brew cycle has ended and water drip out has stopped, 

carefully remove the pod holder and remove any excess water.

Unplug the brewer and wait for it to cool. If your Pod brewer has been 

used, it must be stored above 32° F / 0° C to prevent damage to the internal 

water tank. Empty and dry the water reservoir before storing.
NOTE: Water will remain in the internal tank. If stored for an extended 

P2942