Bunn MCP Manuale Utente

5

• 

•  This brewer is designed to remain plugged in at all times (except during 

initial installation, cleaning, or when brewer will not be used for an extended 
period of time).

•  A power switch is provided on the lower left side to completely shut off all 

electrical components when your plans take you away from the brewer for 
three or more days. Safety features, designed into the BUNN

®

 Pod brewer, 

make the daily use of this switch unnecessary.

•  Whenever the brewer has been shut off or unplugged for an extended period 

of time, rinse the reservoir and refill with fresh cold water before using. It is 
also recommended that the brewer be cycled. (See page 15)

•  Your BUNN

®

 Pod brewer has a specially designed tank to keep the water 

inside at the proper temperature. This constant supply of hot water assures 
the correct method of brewing in less than one minute.

•  When inserting a pod into the pod holder, it is important to seat the pod all 

the way into the holder cavity. Leaks could occur if the pod is too large, or 
does not seat completely into the holder cavity. Ensure that all of the paper 
edge and any tabs of the pod are inserted into the holder cavity.

•  While brewing, the newest water in the tank is also being heated to the 

proper temperature and held until needed.

•  The brewer is equipped with a 120 volt, 3-prong grounded cord set. The plug 

is provided with a round grounding pin. This is a safety feature and allows 
the plug to fit into a properly grounded outlet. If the plug does not fit into the 
outlet, contact an electrician to update your outlet. Attempting to bypass the 
safety aspect of this plug will void the warranty.

•  The sprayhead may become loose over time. Unplug the machine and allow 

it to cool down before tightening or removing the sprayhead. Use extreme 
caution not to burn yourself. Tighten or remove the sprayhead with your 
fingertips.  (Refer to page 14)

• 

CAUTION: Never apply force to remove the pod holder. If the holder does 
not slide out easily, wait 10 minutes and try again. Burns resulting from hot 
water splash could occur if the holder is forcibly removed from the brewer.

•  Use 

CAUTION to avoid burns during consumption of any freshly brewed 

beverage. Servings are extremely hot.

•  To stop a brew cycle in process, press the Coffee or Tea button again. (See 

Page 7)

•  When operating the brewer on a standard household outlet, do not attempt 

to power other appliances on the same circuit. Circuit overload could occur.