Bunn MCP Manuale Utente

7

•  WATER RESERVOIR - Holds reserve water for brewing. The reservoir can 

be removed and filled separately at a sink or other clean water source or by 

pouring water through the slide lid. (Holds 46 oz. to the maximum line.)

•  SLIDE LID - The slide lid allows access to the reservoir. Water can be 

poured through the opened lid and into the reservoir without removing the 

reservoir.

•  POD HOLDER RELEASE BUTTON - Push to unlock and release the pod 

holder. When there is power to the brewer, this button will illuminate red 

in color, showing the trademark BUNN name. This light will go out during 

a brew cycle and when the brewer has gone into Sleep Mode. (Refer to the  

“Features” section on page 8 for more information.)

•  BLUE (BREW) LIGHTS - Blue colored lights are located near the pod holder  

area and light up to indicate that a brew cycle is in process.

•  SPRAYHEAD SEAL - The seal keeps water under pressure from escaping, 

while a brew cycle is in process. If leaks are present during a brew cycle, 

consult the “Troubleshooting” section on page 16.

•  SPRAYHEAD - Designed to distribute water evenly across the coffee pod or 

tea bag/pod to extract the proper flavor.

•  POD HOLDER INSERT - A color-coded, removable screen designed to allow 

proper flow rates and steeping capabilities for the type of brew desired.

•  POD HOLDER - Holds the coffee pod or tea bag/pod.
•  DRIP TRAY GRATE - A removable part that allows any spilled liquid to drip 

through into the drip tray.

•  DRIP TRAY- Removable tray that is designed to catch any spilled liquid.
•  POWER SWITCH- Turns on and off all electrical service to the brewer. This 

button is only to be used when the brewer will not be used for several days. 

(In the “I” position the power is on. In the “O” position the power is off.)

•  VOLUME CONTROL SLIDE LEVER - Adjusts the amount of water dispensed 

through the pod holder. Sliding it left will produce a smaller serving. Sliding 

it to the right will produce a larger serving. The brewer will dispense 

approximately 4 oz. to 12 oz. in one ounce increments.

•  CONTROL PANEL - Controls for brewing coffee or tea and various 

indicators are located on the control panel. (FIG. 2)  See specific definitions 

below.

•  COFFEE BREW BUTTON - Depress this button to brew a serving of coffee. 

Pressing it again will cancel a brew cycle in process. 

•  REFILL WATER INDICATOR - If the water in the reservoir is running low, and 

either the Coffee or Tea  Brew button is pressed, this indicator will flash for 

a few seconds to show that the water reservoir needs to be refilled. A brew 

cycle cannot be started until the reservoir has been refilled.

•  HEATING INDICATOR - This light indicates that the heater is bringing water 

up to temperature. A brew cycle cannot be started until the indicator has