Bunn MCP Manuale Utente

8

gone out. (During a brew cycle, this light will come on indicating the tank 

heater is warming the new water entering the tank.)

•  POD HOLDER INDICATOR - This indicator identifies a missing or unlocked 

pod holder. Before a brew cycle can be started, the pod holder must be  

inserted and locked into place. 

•  TEA BREW BUTTON - Depress this button to brew a serving of tea or 

coffee. 

Pressing it again will cancel a brew cycle in process. You will 

notice that the water flow will pulse on and off when brewing with this 

setting. This is normal. (Can also be used to brew a stronger more robust 

serving of coffee.)

•  VOLUME CONTROL INDICATOR - The markings on the bottom of the 

control panel correspond to the VOLUME CONTROL SLIDE LEVER and are 

used for setting the brew volume. (Approximately 4 oz. to 12 oz. servings in 

one ounce increments can be brewed based on the setting of the lever.)

•  SLEEP MODE - If the brewer has been idle for 6 hours, it will reduce power 

to conserve energy. After 2 weeks, the brewer will shut down completely. 

When either of these two sleep modes occur, the Pod Holder Release 

Button will no longer be glowing red. To wake the brewer up, press either 

the Coffee or Tea Brew button, or eject the pod holder. The light and 

heater will come back on.

•  BREW CANCEL - If it is necessary to cancel a brew cycle, this can be done 

by pressing either the Coffee or Tea button again. Although some water 

may drip out, the pump will immediately stop forcing water through the 

pod holder. Always wait for hot liquid to stop before removing the pod 

holder.

CAUTION: When a brew cycle is canceled, it will not finish dispensing it’s 

to pressing the button a second time.
•  MIN & MAX MARKINGS - The side of the water reservoir bears the  

markings “MIN” and “MAX”. These markings indicate the minimum and 

maximum amount of water that can be placed in the reservoir. If the 

minimum amount of water is not in the reservoir, the brewer will not 

operate. These markings are referenced throughout this booklet. 

•  PULSE BREW™ - Using the Tea Button will cause the brewer to perform 

a pulse brew operation. A Pulse Brew cycles the water on and off to 

effectively steep the tea to extract the proper flavor. The “On-Off-On” water 

flow is normal. Always wait for the blue (brew) lights to go out, and the 

red BUNN light o come back on before carefully removing the mug or pod 

holder.  Pressing either brew button during this operation will stop the 

brew cycle. (See the “Brew Cancel” feature above for more information.)