Hoshizaki DCM-750BWH(-OS) Manuale Utente

22

CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are 
securely in place after installation. Make sure that none have fallen into the 
storage bin.

1) Is the icemaker level?
2) Is the icemaker in a site where the ambient temperature is within 45°F to 100°F (7°C to 

38°C) and the water temperature within 45°F to 90°F (7°C to 32°C) all year around?

3) Is there at least 6" (15 cm) clearance at rear and sides and 24" (61 cm) at top for proper 

air circulation and ease of maintenance and service?

4) Have the shipping carton, tape, and packing material been removed from the 

icemaker?

5) Are all components, fasteners, and thumbscrews securely in place? 
6) If the icemaker is on a stand, has it been secured to the stand as outlined in the  

stand's installation instructions? If the icemaker is mounted flat to a counter, has the 
perimeter where the icemaker contacts the counter been sealed with approved caulk 
compound?

7) Have all electrical and water connections been made? Do electrical and water 

connections meet all national, state, and local code and regulation requirements? 

8) Has the power supply voltage been checked or tested against the nameplate rating? 

Has a proper ground been installed to the icemaker?

9) Are the water supply line shut-off valve(s) and drain valve(s) installed? Has the water 

supply pressure been checked to ensure a minimum of 10 PSIG and a maximum of 
113 PSIG?
Note: The icemaker may stop running when the water supply is off, or if the pressure 

is below 10 PSIG. When the proper water pressure is reached, the icemaker 
automatically starts running again.

10) Are the compressor hold-down bolts snug? Have the refrigerant lines been checked 

to make sure they do not rub or touch other lines or surfaces? Has the fan blade (if 
applicable) been checked to make sure it turns freely?

11) Has the end user been given the instruction manual, and instructed on how to operate 

the icemaker and the importance of the recommended periodic maintenance?

12) Has the end user been given the name and telephone number of an authorized service 

agent?

13) Has the warranty card been filled out and forwarded to the factory for warranty 

registration?