GE Monogram ZXR859 Manuale Utente

• Tape the wire to the front of the frame support to

prevent damage during installation and service.

Ceiling

Support

Frames

Tape

House

Wiring

Front Side

• Measure from top duct connector (Dim. A) to

bottom of support frame.

– Add at least 1

″ for duct overlap at the top.

– Subtract 1-3/4

″ for hood insertion into the bottom

of the frame.

• Cut the 6

″ dia. duct to the required length.

• Route house wiring through the ceiling hole and

pull a length to reach the hood junction box,
approximately 6

″ below the support.

 The top and bottom of the duct are external

(female) connections. The bottom end should be
flared slightly, to facilitate installation of the hood.
• Install duct up through support frames onto the top

duct connector. Push duct up until it is 1-3/4

″ from

the bottom of support frame flange. See illustration.

Ceiling

Duct

Duct Connection
To Hood

Bottom Support 

Frame Flange

1-3/4"

Side

View

Support

Frame

Required

Duct

Length

Duct Connector