Intel 8XC196Lx Manuale Utente
8XC196L
X SUPPLEMENT
2-6
To program these bits, write the correct value to the locations shown in Table 2-4 using slave pro-
gramming mode. During normal operation, you can determine the values of these bits by reading
the UPROM SFR (Figure 2-5).
gramming mode. During normal operation, you can determine the values of these bits by reading
the UPROM SFR (Figure 2-5).
You can verify a UPROM bit to make sure it programmed, but you cannot erase it. For this rea-
son, Intel cannot test the bits before shipment. However, Intel does test the features that the UP-
ROM bits enable, so the only undetectable defects are (unlikely) defects within the UPROM cells
themselves.
son, Intel cannot test the bits before shipment. However, Intel does test the features that the UP-
ROM bits enable, so the only undetectable defects are (unlikely) defects within the UPROM cells
themselves.
2.5
INTERNAL PERIPHERALS
The internal peripheral modules provide special functions for a variety of applications. This sec-
tion provides a brief description of the peripherals that differ between the 8XC196Lx and the
8XC196Kx families.
tion provides a brief description of the peripherals that differ between the 8XC196Lx and the
8XC196Kx families.
USFR1 (read only)
Address:
Reset State:
1FF2H
XXH
The UPROM special-function register 1 (USFR1) reflects the status of unerasable, programmable
read-only memory (UPROM) locations. This read-only register reflects the status of two bits that
control the output frequency on CLKOUT.
read-only memory (UPROM) locations. This read-only register reflects the status of two bits that
control the output frequency on CLKOUT.
7
0
—
—
—
—
—
—
CLK1
CLK0
Bit
Number
Bit
Mnemonic
Function
7:2
—
Reserved.
1:0
CLK1:0
CLKOUT Control
These bits reflect the programmed frequency of the CLKOUT signal:
CLK1 CLK0
0
0
divide by 1 (CLKOUT = f/2)
0
1
divide by 2 (CLKOUT = f/4)
1
0
divide by 4 (CLKOUT = f/8)
1
1
divide by 1 (CLKOUT = f/2)
Figure 2-5. Unerasable PROM 1 (USFR1) Register (LA, LB Only)
Table 2-4. UPROM Programming Values and Locations
To set this bit
Write this value
To this location
CLK0
0001H
0768H
CLK1
0002H
0728H