Multi Tech Equipment MVH306DS2 Manuale Utente

„

dO  nOT charge battery with the battery cables 

connected to the compactor. The diodes will be damage 

by the high voltage.

 

„

Batteries generate hydrogen gas which 

can be highly explosive. 

dO nOT smoke 

or allow flames or sparks near the battery, 

especially during charging of the battery.

 

„

Charge the battery in a open air environment (plenty of 

ventilation).

 

„

Before charging , remove the cap from each cell of the 

battery.

 

„

Connect the positive (+) lead of the charger to the 

positive (+) terminal of the battery and the negative (-) 

lead of the charger to the negative (-) terminal of the 

battery. 

dO nOT reverse the polarity when charging. 

Reverse polarity will damage the charger rectifier or 

the battery.

 

„

Battery fluid will be lost through continuous charging 

and discharging.

 

„

Discontinue charging if the electrolyte temperature 

exceeds 117° F (45° C).

During summer much more battery fluid is lost than in 

winter. Before starting, check battery electrolyte levels 

and replenish with distilled water to the upper mark on 

the battery.

1.  Take off the battery cover by removing the M6 nuts that 

secure the battery holder to the cover.

2.  When removing battery cables, disconnect the ground 

side (normally negative) first (Figure 39).

3.  When installing battery cable connect the ground side 

(normally negative) last.

1.  Clean the fuel filter every 3 months or 200 hours.
2.  Replace fuel filter every 6 months or 400 hours.
3.  To clean the fuel filter, loosen the nuts (Figure 40) of 

the fuel cock and pull out the filter from the F.O. tank 

filler port. Wash the filter thoroughly with diesel fuel oil.

4.  Reinstall fuel filter and connect all associated hardware

NUTS

DRAIN
PLUG