U-Line CO2175/CO2275DWR Manuale Utente

NOTE: If door is adjusted correctly, but panel is not square with the 
adjacent cabinets, slight adjustments can be made by drilling the holes 
in the vinyl-coated steel panel slightly oversized (Figure 37).

1. Remove top hinge screw pin using a Phillips screwdriver (Figure 

38). Remove door by tilting forward and lifting off bottom hinge 
pin.

2. With door upside-down, loosen but do not remove the two 

screws on the door’s bottom hinge plate.

3. See Figure 39 and Figure 40. If the top far edge of the door 

needs to move UP, move the hinge plate toward the outside of the 
door and retighten screws. If the top far edge of the door needs to 
move DOWN, move the hinge plate toward the inside of the door 
and retighten screws.

4. Mount the door to recheck alignment and repeat steps 2 and 3 if 

further adjustment is necessary.

5. When top edge of door is parallel to top edge of cabinet, remove 

the door and ensure the two screws are secure.

6. Remove the door closers from the bottom hinge, clean thoroughly 

and lubricate the mating surfaces with petroleum jelly.

7. Reinstall the closers, lining up the bosses with holes in hinge and 

hinge plate (Figure 41).

Drill 5/32" x 3/8" Deep for use
with #10 x 5/8" Wood Screw
and Nylon Spacer – 6 Places

1"

±1/8"

1"

±1/32"

1"

±1/32"

14-5/16"

±1/4"

27"

±1/4"

Rear View

of

Wood Panel

ULIN_0310_A

ULIN_0133_A

Notch must face center of door

Slotted 

Mounting 

Holes 

Raise 

Outside 

Door Edge 

Lower 

Outside 

Door Edge 

ULIN_0297_A

Angled Edge

Towards Center

of Door

Slotted

Mounting

Holes

Raise

Outside

Door Edge

Lower

Outside

Door Edge

ULIN_0311_A