U-Line CO2175/CO2275DWR Manuale Utente
3-50
Section 3 - Service and Repair
CHECKING DRAWER ALIGNMENT
The unit’s drawers are aligned at the factory before shipment.
However, their alignment could have been disturbed during
shipment or during overlay panel installation.
However, their alignment could have been disturbed during
shipment or during overlay panel installation.
Figure 44
See Figure 44. Check each drawer to confirm that it is aligned:
• Side-to-Side — When viewed from the top, the drawer front
should be square with the sides of the cabinet.
• Front-to-Back — When viewed from the side, the drawer
front should be straight with the cabinet’s sides, not cocked
forward or back.
forward or back.
• Top-to-Bottom — When viewed from the front, the drawer
should be level horizontally.
If both drawers are properly aligned, no further adjustment is
necessary. If either drawer is not aligned, carefully follow
instructions to remove that drawer, make the necessary
adjustment and re-install the drawer.
necessary. If either drawer is not aligned, carefully follow
instructions to remove that drawer, make the necessary
adjustment and re-install the drawer.
ADJUSTING DRAWER ALIGNMENT
WARNING
SHOCK HAZARD — The unit must be unplugged from
the wall outlet during drawer removal, adjustment and
re-installation.
the wall outlet during drawer removal, adjustment and
re-installation.
DRAWER REMOVAL
1. Confirm that the unit is unplugged from wall outlet.
2. Unplug the drawer’s connection wiring (top drawer only).
3. Remove the mounting screws (Figure 45 and Figure 46).
Figure 45
4. Pull the drawer completely out of the unit.
CAUTION
Use care when handling the drawer. Drawer edges, drawer
rail and the unit’s slide may be sharp.
rail and the unit’s slide may be sharp.
IMPORTANT
IMPORTANT
Drawer adjustments are made by moving the slide that
carries the drawer’s rail. Minor adjustments may be made
by loosening one of the slide’s mounting screws, adjusting
the slide and retightening the screw. Severe adjustments
may be made by removing the slides’ mounting screws,
drilling new mounting holes and remounting the slide.
carries the drawer’s rail. Minor adjustments may be made
by loosening one of the slide’s mounting screws, adjusting
the slide and retightening the screw. Severe adjustments
may be made by removing the slides’ mounting screws,
drilling new mounting holes and remounting the slide.
Aligned
Side-to-Side
Aligned
Front-to-Back
Aligned
Top-to-Bottom
ULIN_0312_A
g
n
i
t
n
u
o
M
w
e
r
c
S
ULIN_0313_A