Mustang Survival MD1250 Manuale Utente

10.  Ensure the bladder fabric is wrapped tightly around the CO2 cylinder 

and the hydrostatic inflator (Figures 14–16).

11.  Remove the vacuum fitting from the oral inflation tube.
12.  Detach the automatic/manual conversion cap (MA7219) from the 

hydrostatic inflator. The pressure within the bladder should increase as 
some gas enters through the water inlet valve.  If the volume of gas 
contained within the bladder does not noticeably increase, repeat steps 1-12.

13.  On the oral inflator tube, turn the locking ring counterclockwise to 

close the inflator valve and lock the mouthpiece in position.

1.  Place the LP on a clean, flat surface with 

the hydrostatic inflator face down, and 
fold the inflation cell along each folding 
line in sequence, numbers 1–11 (Figure 17).

2.  Carefully but firmly wrap the outer casing 

of the LP around the folded inflation cell, 
secure with Velcro® tab and reset and close 
the zippers.

When performing this procedure, ensure the inflation cell does not get 
caught in either zipper.
To reset and close the zippers:
1.  Reset the zippers by pulling 

each zipper pull back to the 
Velcro

® tab on the top of the 

LP (Figure 18).

2.  Close the zippers by pulling each 

zipper pull to the zipper tape 
ends at the top and bottom of 
the LP (Figure 19), and fasten the 
tab to keep the zippers closed.

3.  Feed the zipper tape ends into 

the small openings on the LP.

Figure 18

Figure 19

Figure 17

Figure 14

Figure 15

Figure 16

INFLATED

DEFLATED

VACUUMED

Tactical Inflatable Side Pouch LP 

 

8