Garmin 7212 Manuale Utente

Almanac, Environmental, and On-boat Data 

The chartplotter must be connected to a depth-capable transducer to capture the data shown on the 

depth graph.

From the Home screen, select 

 > 

 > 

.

If you have turned on and configured the shallow water and deep water alarms (

graph shows in red any water depth data that is less than the depth specified for the shallow water 

alarm, and it shows in red any water depth data that is greater than the depth specified for the 

deep water alarm.

You must be connected to a NMEA (National Marine Electronics Association) 2000 network capable 

of sensing engine data to view engine gauges. See the GPSMAP 6000/7000 Series Installation 

Instructions for details. 

From the Home screen, select 

 > 

.

1.  From the Home screen, select 

 > 

.

2.  Move from one gauge screen to the next:

For the GPSMAP 6000 series, use the Rocker. 
For the GPSMAP 7000 series, select the left and right arrows at the top of the page.

The chartplotter shows the next engine gauge or fuel gauge screen.

3.  Repeat step 2 to cycle through all the engine gauge and fuel gauge screens.

You can configure up to four values for each engine gauge or fuel gauge, to establish the upper and 

lower limits of the gauge, and the range of desired standard operation. When a value exceeds the 

range of standard operation, the gauge face or bar becomes red.

Scale minimum

This value is less than the scale minimum, and it represents the lower limit of the gauge. 

This setting is not available on all gauges.

Scale maximum

This value is greater than the scale maximum, and it represents the upper limit of the 

gauge. This setting is not available on all gauges.

Rated minimum

Represents the minimum value of the standard operating range.

Rated maximum

Represents the maximum value of the standard operating range.

1.  From the Home screen, select 

 > 

 > 

 > 

 > 

.

2.  Select a gauge.
3.  Select 

 > 

.

•
•