Garmin 7212 Manuale Utente

Almanac, Environmental, and On-boat Data 

You must manually select the number of engines shown in the engine gauges (

can select the engines for which information appears in the gauges.
1.  From the Home screen, select 

 > 

 > 

 > 

 > 

.

2.  Select 

.

3.  Enter the number of the engine (1 through 8) for which you want to view information in the first 

gauge or bar:

For the GPSMAP 6000 series, use the Rocker or Numeric Keypad.
For the GPSMAP 7000 series, use the on-screen keyboard.

For example, if you select “6,” the first engine gauge or bar shows information for the engine 

identified as “Engine6” on the NMEA 2000 network.

4.  Select 

.

5.  Repeat steps 3 and 4 for the second, third, and fourth engine gauge or bar, as needed. 

A maximum of two fuel gauges, an upper gauge and a lower gauge, appear above and below the 

speedometer in the center of the Fuel Gauges page. You must have fuel level sensors in your fuel 

tanks or a fuel flow sensor to capture the data shown in the fuel gauges. 
If you use only a fuel flow sensor, the amount of fuel onboard is the estimated fuel level, and it is 

based on the total tank size, the recorded amount of fuel in the tanks, and the fuel flow rate.
The number and configuration of fuel gauges that appear is based on the number and type of onboard 

fuel data sensors, as shown below.

No fuel gauges appear.

Upper fuel gauge appears.

Upper and lower fuel gauges 

appear.

Upper fuel gauge appears 

with estimated fuel level.

Upper fuel gauge appears.

Upper and lower fuel gauges 

appear.

To view fuel information, your chartplotter must be connected to an external fuel sensor, such as the 

Garmin GFS

™

 10.

1.  From the Home screen, select 

 > 

.

2.  Move from the engine gauge screens to the fuel gauge screen:

For the GPSMAP 6000 series, use the Rocker. 
For the GPSMAP 7000 series, select the left and right arrows at the top of the page.

).

•
•

•
•