Regency Wraps U41-LP3 Manuale Utente

Regency U41-3 ULTIMATE Gas Fireplace Insert

INSTALLATION

Tabs

Screws

Right
Side

Top

Hinged
Louvers

3) Using the trim clips provided, join the left side

gold trim (the one with the ON/OFF switch
and variable speed FAN switch) to the top
gold trim. See diagram 2. Repeat this step
for right side.

8) Fan Switch wires: Connect the plug end

from the fan switches to the matching plug
from the unit. See Diagram 5. Make sure
the plugs are pushed together as far as they
can go. Push the connection into the hole
in the side of the insert so it is locked into
place.

9) ON/OFF wires: Hook up the ON/OFF wires

to the switch on the left side trim. Diagram
5.

Trim Clips

tighten top
screw only

Rear View

Diagram 3

Diagram 4

Diagram 5

FACEPLATE AND TRIM

INSTALLATION

Hint:

Before doing the faceplate installation,
leave the Insert out approximately
4" so wires may be hooked up more
easily.

1) Lay the faceplate panels ﬂ at, face down on

something soft so they don't scratch.

2) Take the top faceplate and align the holes in

it with the holes in the side panels. Attach,
using the screws provided. See diagram
1.

Diagram 1

Diagram 2

shut off the supply of gas within 5 - 10
minutes. Tampering with the switch
can result in carbon monoxide (CO)
poisoning and possible death.

If the heater turns off because of lack
of draft during the spillage test, check
for the cause and if necessary, seek
expert advice.

The thermally actuated safety switch
will automatically reset after it has
reduced in temperature. The switch
will continue to cycle until the draft
problem is corrected. DO NOT
BYPASS OR DISCONNECT THIS
SWITCH.

Note: The holes in the top panel are slightly

larger than the holes in the side panel
to facilitate easier installation.

Hint: Don't tighten the screws down completely
at this point, ﬁ rst do a trial ﬁ t to the unit. Make
any necessary adjustments and when it ﬁ ts
properly then tighten down the screws.

4) Place the trim on the assembled faceplate

panels, aligning the wires from the switches
with the notch in the left side faceplate
panel.

The power cord should be run behind the
faceplate panel.

5) Push the Regency logo plate into the two

holes in the bottom left corner of the face-
plate.

6) Secure the brass trim to the faceplate by

drilling a 1/8" hole through into the faceplate
side ﬂ ange, using the hole in the brass trim
as a guide. Now fasten with the two brass
plated screws provided.

7) Lift the assembled faceplate up and over the

top of the insert and then lower it down so the
faceplate tabs are in line with the faceplate
brackets. See diagram 3. Once everything
is properly lined up you can tighten the 4
screws on the faceplate brackets. See
diagram 4.

Note: If you are making custom face-plates,

you must use the faceplate louvers.
Failure to do so will void the certiﬁ ca-
tion on your unit. The faceplate lou-
vers can be purchased separately.