Broilmaster H3XPK-1 Manuale Utente

B101623-5-1012

Page 47

Before each use, inspect all hoses. If it is evident there is 

excessive abrasion or wear, or the hose is cut, it must be  

replaced prior to using your Broilmaster grill. Call your local Broil-

master dealer for a replacement.

OFF for 5 minutes, to allow the gas to clear, then try again.
Note: Each burner must be lit individually.
1.  Turn knob on the grill CLOCKWISE to the OFF position.

2.  Turn ON gas at the source.

3.  With the grill lid open, push and turn the burner control knob 

COUNTERCLOCKWISE to Hi.

4.  Push and hold the ignitor button until the burner lights (approxi-

mately 5 seconds).

5.  If a burner does not light, turn OFF all gas and refer to the 

Troubleshooting section of this manual.

6.  Repeat steps 3 through 5 for other burner.

OFF for 5 minutes, to allow the gas to clear, then try again.
Note: Each burner must be lit individually.
1.  Turn knob on the grill CLOCKWISE to the OFF position.

2.  Turn ON gas at the source.

3.  Open the grill lid.  

4.  For Blue Flame grills, insert a burning long wooden match 

through the lighter hole on the left side of the grill. For Infrared 

grills, insert the lighting stick with a long wooden match attached 

through the cooking grid to ignite the infrared burner from the 

top. 

5.  Turn the burner control knob COUNTERCLOCKWISE to HI.  

6.  If a burner does not light, turn OFF all gas and refer to the 

Troubleshooting section of this manual.

7.  Repeat steps 3 through 6 for other burner.

Check for gas leaks every time you connect your Broilmaster

 

 pro-

pane gas grill to a Propane gas cylinder, when a connected cylinder 

has not been used recently, or when either a natural or propane grill 

is being used for the first time. 
Caution:  Do not use an open flame when checking for leaks.  

explosion, resulting in property damage or personal injury. 
To check for gas leaks:
1.  Use dish washing liquid and a little water to make a soapy solu-

tion.

2.  Turn OFF the knob on the control panel.

3.  Turn ON the gas at the supply or cylinder.  A hissing sound 

indicates a leak.  Turn OFF the gas and repair the leak.

4.  Apply the soapy water solution to all gas connections.

5.  Look for bubbles.  Bubbles indicate a leak.

6.  If there are bubbles turn OFF the gas and repair the leak.

7.  Turn the gas back ON and repeat the above procedures until 

all leaks are repaired.

The burner (venturi) tube air shutter is preset at the factory so 

that after five minutes the burner flames are blue with well defined 

cones.  If, after five minutes the flame is yellow, or there is a gap 

between the burner and the flame, adjust the burner (venturi) tube 

air shutter as follows:
1.  Turn gas OFF and let the burner cool.

2.  Beneath the control panel you can access the air shutter(s) 

which are located on the end of the burner tubes.

3.  Loosen shutter set screw  

4.  Close the air shutter to the minimum opening. 

5.  Light the burner, wait five minutes and then carefully open the 

air shutter until the flame is blue and well defined.

6.  Retighten the set screw.

LIGHTING STICK
R734

KEEP HAND AWAY FROM
TOP OF GRILL WHEN LIGHTING
INFRARED BURNER

MATCH LIGHT HOLE
BLUE FLAME BURNER