Exmark LAZER Z HP Manuale Utente

- 16 - 

 

 

 

 

 

 

 

 

 

 

 

 

 

 
 

 
 
 
 

LOWER ROLL BAR INSTALLATION 

 

3.2.5 

Install the upper u-shaped section of the roll bar. (Reference Figure 3 for 
alignment and installation instructions below): 

 

 

 

a)  Locate the latch pin assemblies (pin and hairpin connected with a lanyard).   

 

 

 

b)  Install a 1/2-13 x 3 1/4 capscrew in the washer on the lanyard of each pin 

assembly.  

 

 

 

Note: Make sure the bent tab in the washer points toward the head of the 
capscrew.   

  

 

b) 

Lightly oil the inside surfaces of the ear-shaped plates at the upper end of 
the lower roll bar tubes.   

 

 

 

c)  Locate the upper u-shaped section of the roll bar. Install the upper roll bar 

section using one 1/2-13 x 3 1/4 capscrew (from step b) and one 1/2-13 hex 
flange lock nut on each side.   Do not over tighten.  Make sure upper roll bar 
can pivot freely. 

  

 

Notes: 

 

• Make sure the capscrew and nuts are installed with the nut to the inside of 

the roll bar. 

• Make sure the tab on the lanyard washer is installed as shown and points 

toward the front of the unit. 

 

d)  Raise the roll bar into the upright position and secure with the latch pin 

assemblies on each side.  Install latch pin from outer surface of roll bar 
assembly and secure with the hairpin to the inside. 

 

 

 

e)  Torque all lower roll bar hardware attached to the machine frame to 30-35 ft-

lbs. (41-47 N-m). 

 

 

 

f)  Tighten the front knobs against the upper roll bar ends.