Exmark LAZER Z HP Manuale Utente

Pagina di 56
- 17 - 
 
 
 
 
 
 
 
 
 
 
 
 
 
FIGURE 3 
UPPER ROLL BAR INSTALLATION 
3.3 SERVICE BATTERY
 
 
 
 
 
 
 
The machine is shipped with a filled lead acid battery. 
3.3.1 
Unhook seat latch and tilt seat up to gain access to the battery. 
      
DANGER 
POTENTIAL HAZARD 
♦  Charging the battery may produce explosive gasses 
WHAT CAN HAPPEN 
♦  Battery gasses can explode causing serious injury. 
HOW TO AVOID THE HAZARD 
♦  Keep sparks, flames, or cigarettes away from battery. 
♦  Ventilate when charging or using battery in an 
enclosed space. 
♦  Make sure venting path of battery is always open once 
battery is filled with acid. 
 
3.3.2 
Check the voltage of the battery with a digital voltmeter. Locate the voltage reading 
of the battery in the table below and charge the battery for the recommended time 
interval to bring the charge up to a full charge of 12.6 volts or greater.  
 
 
IMPORTANT:  Make sure the negative battery cables are disconnected and the 
battery charger used for charging the battery has an output of 16 volts and 7 
amps or less to avoid damaging the battery (see the following chart for 
recommended charger settings). 
Voltage 
Reading 
Percent 
Charge 
Maximum  
Charger Settings 
Charging Interval 
12.6 or greater  100% 
16 volts/7 amps 
No Charging Required
12.4 – 12.6 
75 – 100% 
16 volts/7 amps 
30 Minutes 
12.2 – 12.4  
50 – 75% 
16 volts/7 amps 
1 Hour 
12.0 – 12.2 
25 – 50% 
14.4 volts/4 amps 
2 Hours 
11.7 – 12.0 
0 – 25% 
14.4 volts/4 amps 
3 Hours 
11.7 or less 
0% 
14.4 volts/2 amps 
6 Hours or More 
WARNING: Battery posts, terminals, and related accessories contain lead compounds, chemicals known 
to the State of California to cause cancer and reproductive harm.  Wash
 
hands after handling.