Hans Grohe 35807801 Manuale Utente

3

Position the faucet and sealing ring on top of the 

mounting surface.  From beneath, install the plastic 

washer, slide washer and metal washer.  Thread on 

the collar nut loosely. 

If the total thickness of the mounting surface is greater 

than 1 3/8”, omit the plastic washer. 

Inspect the placement of the faucet.  Reposition if 

necessary. 

Turn the water supplies off before removing the old faucet.  

Flush the supply lines of debris before beginning installation. Damage to the cartridge 

caused by debris is not covered under the Hansgrohe limited lifetime warranty.

The spout should swivel equally to the right and to 

the left.  If it appears to swivel more to one side than 

to the other, pivot the faucet body until the swivel is 

even.  

When you are satisfied that everything is oriented 

properly, finish tightening the collar nut.  Tighten the 

tensioning screws.