England's Stove Works 55-SHPEP Manuale Utente

Page | 18 
 

The control board on this stove allows the user to adjust the heat output and 
convection blower speed, turn the unit on and off, and test components for function 
(more on diagnostic mode later). 

•  The lower buttons on the control board (Low Fuel Feed, Low Burn Air, and Air 

on Temp) are not meant to be adjusted during normal operation of the unit.  
These buttons are factory preset and should not be adjusted by the user. 

•  To energize the unit and initiate a fire, press the “On” button.  The LED above 

the button should turn green and the control board should display “S U” shortly 
after pressing the button. 

•  To shut the unit down, press the “Off” button.  The LED above the button 

should turn red and the board should display “S d” shortly after pressing the 
button.  This initiates the shut down sequence, and the stove will remain in shut 
down mode until it has cooled down. 

•  To increase the heat output of the stove, press the “Up” heat range button.  The 

number in the heat range display window will increase, signifying that the 
control board is now adjusting the heat output to your desired level.  The blower 
speed will increase the same amount as the heat range, because the stove is 
designed to operate with the blower speed greater than or equal to the heat 
range.  Pressing the “Down” arrow will decrease the heat range and blower 
speed. 

•  To increase the blower speed without increasing the heat range, press the 

Blower Speed “Up” arrow until the desired blower speed is shown in the 
display window.  Pressing the “Down” arrow will decrease the blower speed; 
however the control board will not allow the blower speed to be set lower than 
the heat range.