Broilmaster SBG2500-1 Manuale Utente

Pagina di 24
SBB00101-1-1007
Page 16
OPERATION
Checking for Gas Leaks
Check  for  gas  leaks  every  time  you  connect  your  Superb  by 
Broilmaster
®
 propane gas grill to a Propane gas cylinder, when a 
connected cylinder has not been used recently, or when either a 
natural or propane grill is being used for the first time.
Caution: Do not use a flame when checking for leaks. Checking 
for leaks with a flame may lead to a fire or explosion, resulting 
in property damage or personal injury.
To check for gas leaks:
1.  Use dish washing liquid and a little water to make a soapy 
solution.
2.  Turn OFF the knobs on the control panel.
3.  Turn ON the gas at the supply or cylinder. A hissing sound 
indicates a leak. Turn OFF the gas and repair the leak.
4.  Apply the soapy water solution to all gas connections.
5.  Look for bubbles. Bubbles indicate a leak.
6.  If there are bubbles turn OFF the gas and repair the leak.
7.  Turn the gas back ON and repeat the above procedures until 
all leaks are repaired.
Air Shutter Adjustment
1.  Remove cooking grids and flame tamers from grill.
2.  Ignite burners on grill and observe flame pattern. If flame is 
yellow in color or flame is lifting off burner the air shutter on 
burner will require adjustment.
3.  Turn gas OFF and allow the grill to cool.
4.  Loosen two (2) Phillips screws at end of each burner. Lift 
upward and pivot burner out of grill.
5.  Loosen Phillips screw at air shutter. Open air shutter for a 
yellow flame or close air shutter for a lifting flame. Tighten 
Phillips screw at air shutter.
6.  Replace burners into grill. Tighten two (2) Phillips screws at 
end of each burner.
7.  Ignite burners on grill to verify burner flame characteristics.
OPERATING INSTRUCTIONS
Using the Ignitor
Caution: If a burner fails to light after 5 seconds, turn the 
burner OFF for 5 minutes, to allow the gas to clear, then try 
again.
Attention:
 You should use the center burner(s) to ignite the first 
burner, then move from center to both sides.
Attention: The control knob that is second from left side of grill 
is for the rotisserie. See Rotisserie Operation on page 12.
1.  Turn the right control knob clockwise 
 to the OFF 
position.
2.  Turn ON gas supply to the grill.
3.  With the grill lid open, push and turn the right control knob 
counterclockwise
 to HI. 
4.  Push and hold in the ignitor button until the right burner ig-
nites.
5.  If right burner does not ignite, turn right control knob clockwise 
 to the OFF position. Turn OFF gas supply to grill. 
Refer to Troubleshooting section in this manual.
OPERATING INSTRUCTIONS
Using Matches
Caution: If a burner fails to light after 5 seconds, turn the 
burner OFF for 5 minutes, to allow the gas to clear, then try 
again.
Attention:
 You must use the control knob on the right side of the 
grill to ignite the first burner. The second burner to be ignited will 
be the second from right side of grill and so forth, always moving 
from right to left.
Attention: The control knob that is second from left side of grill is 
for the rotisserie. See Rotisserie Operation on page 12.
1.  Turn the right control knob clockwise 
 to the OFF 
position.
2.  Turn ON gas supply to the grill.
3.  Open the grill lid.
4.  A match holder is attached on the inside of the right door. Place 
a match into match holder. Insert burning match through the 
lighter hole on right cart side. Place burning match adjacent 
to right burner.
Figure 19
5.  Push  and  turn  the  right  control  knob  counterclockwise 
 to HI.
6.  If right burner does not ignite, turn right control knob clockwise 
 to the OFF position. Turn OFF gas supply to grill. 
Refer to Troubleshooting section in this manual.