Philips AE8000/10 Manuale Utente

Pagina di 28
24 EN
11 Troubleshooting
Warning
 
Never remove the casing of this device.
To keep the warranty valid, never try to repair 
the system yourself. 
If you encounter problems when using this 
device, check the following points before 
requesting service. If the problem remains 
unsolved, go to the Philips Web page (www.
philips.com/support). When you contact Philips, 
make sure that the device is nearby and the 
model number and serial number are available.
No power
 • Make sure that the AC power plug of the 
clock radio is connected properly.
 • Make sure that there is power at the AC 
outlet.
No sound or poor sound. 
 • Adjust the volume.
 • Check whether the radio is muted or the 
radio station is still buffering. 
 • Check whether a headphone is plugged. 
 • Fully extend and adjust the position of the 
radio antenna. 
 • Keep the radio away from other electronic 
devices to avoid radio interference.
 • Check the Wi-Fi network connection. 
Rotate and adjust the position of the Wi-Fi 
antenna. 
No response from the clock radio
 • Disconnect and reconnect the AC power 
plug, then turn on the clock radio again.
 • Check if the radio is in standby mode. If 
yes, turn on the radio. 
Poor radio reception
 • Keep the clock radio away from other 
electronic devices to avoid radio 
interference.
 • Fully extend and adjust the position of the 
radio antenna.
 • Check the Wi-Fi network connection. 
Rotate and adjust the position of the Wi-Fi 
antenna. 
Insufficient Wi-Fi signal strength
 • Check the distance between your router 
and the radio.
 • Rotate and adjust the position of the Wi-Fi 
antenna. 
Cannot connect to your Wi-Fi network
 • Check if your wireless router is switched 
off. 
 • Check if your wireless router supports 
WPS. Use the correct setup method (PBC 
or PIN) to connect your WPS-supported 
router to the radio. If necessary, refer to 
the user manual of your wireless router for 
how to set up Wi-Fi connection.
 • Configure the Wi-Fi settings again (see 
"Get started">"Perform initial setup" 
and "Use system settings menu">"Adjust 
network settings"). 
Some stations do not work sometimes
 • Some stations can only support a limited 
number of listeners. If you try again after 
a few minutes, you will be able to listen to 
the stations. 
 • The station is not broadcasting. Try again 
later.
Some stations disappear from the station list
 • When a station stops broadcasting on 
the Internet, it will be removed from 
the list. The radio will check constantly 
if the station is on the air. If it restarts 
broadcasting, it will be brought back to the 
station list. 
Alarm does not work
 • Set the clock/alarm correctly.