Desa VM36(B,H) Manuale Utente
www.desatech.com
108795-01V
21
INsPeCtING burNers
Continued
BURNER FLAME PATTERN
Burner flames will be steady, not lifting or float-
ing. Flames should go up through the middle
of logset. Flames should not "spill" to edges
of pan or sides of logset.
ing. Flames should go up through the middle
of logset. Flames should not "spill" to edges
of pan or sides of logset.
Thermopile
Pilot
Burner
Burner
Ignitor
Figure 42 - Correct Pilot Flame Pattern
Figure 43 - Typical Flame Pattern
CleaNING aNd maINteNaNCe
Figure 43 shows a typical flame pattern. If
burner flame pattern differs from that de-
scribed:
• turn appliance off (see To Turn Off Gas to
burner flame pattern differs from that de-
scribed:
• turn appliance off (see To Turn Off Gas to
Appliance, page 20)
• see Troubleshooting, page 23
WARNING: Installation and
repair should be done by a quali-
fied service person. The appli-
ance should be inspected before
each use and at least annually
by a qualified service person.
More frequent cleaning may be
required due to excessive lint
from carpeting, bedding mate-
rial, pet hair, etc. It is imperative
that the control compartments,
burners and circulating air sys-
tem be kept clean.
WARNING: The logs can be
hot. Handle only when cool.
WARNING: Turn off gas and
electrical power before servicing
appliance.
WARNING: Failure to keep
the primary air opening(s) of
the burner(s) clean may result in
sooting and property damage.
PILOT AND BURNER
• Remove logs and ember material before
cleaning burner and replace when cleaning
is complete.
is complete.
• Burner and controls should be cleaned
with compressed air to remove dust, dirt
or lint.
or lint.
• Use a vacuum cleaner or small, soft bristled
brush to remove excess dust, dirt or lint.
LOGS
• If you remove logs for cleaning, refer to
log placement information on page 12 to
properly replace logs.
properly replace logs.
• Use a vacuum cleaner to remove any
carbon buildup on logs.
• Replace log(s) if broken. See Replacement
Parts, page 22.
• Replace ember material periodically as
needed. See Replacement Parts, page 22.