Snapper YZ13331be Manuale Utente

 
3.1 INTRODUCTION 
To retain the quality of the YARD CRUISER, use 
genuine SNAPPER replacement parts only.  Contact a 
local SNAPPER dealer for parts and service assistance. 
For the correct part or information for a particular mower, 
always mention the model and serial number.  
 
3.2  SERVICE - AFTER FIRST 5 HOURS 
 

3.2.1.  CHANGE ENGINE OIL 
1.  Place bricks or wooden blocks under the front 
wheels to lower rear of engine. 
2.  Place a 4 quart minimum capacity container 
under the end of the oil drain. 
3.  Loosen or remove oil fill cap on engine. 
4.  Install the drain hose (Supplied in hardware bag) 
onto drain plug nipple and place hose into drain 
container. 
5.  Rotate drain plug counter clockwise and pull out 
to open and allow oil to drain out. See Figure 3.1. 

 

 

 

6. After all the oil has drained, close the drain by 
pushing in and rotating clockwise to close. Wipe up 
any oil that may have spilled. Dispose of drained oil 
properly. See Figure 3.1. 
7.  Change oil filter at every oil change.  Refer to your 
engine owner’s manual for service instructions. 
8.  Fill engine crankcase with new oil.  Refer to your 
engine owner’s manual for oil specifications. 
 
 
 

3.2.2.  CHECK MOWER BLADE 
1.  Make sure fuel cap is on tight. Turn fuel shut off 
valve (If equipped) to the “CLOSED” position. Start 
engine and allow it to run until engine runs out of fuel. 
Close vent on fuel filler cap. See Figure 2.3, Page 6. 
2.  Apply parking brake. 
3.  Turn key to “OFF” position and remove key from 
ignition switch. 

 

 

4.  Carefully stand YARD CRUISER on rear bumper. 
It may be necessary to have help to stand unit up. 
5.  Check torque of blade mounting bolts. Torque to: 
33” Deck - 30 to 40 ft. lbs.  
38” Deck - 80 to 90 ft. lbs. See Figure 3.2. 
6.  Check blade for sharpness, wear and damage. See 
Section on BLADE WEAR LIMITS. 

 

 

7.  Check blade for straightness. 

 

WARNING