Snapper E331523KVE Manuale Utente

 

 
4.3  REAR ENGINE RIDER DRIVE COMPONENTS 

Test the wheel brake on a dry concrete surface. 
When properly adjusted, the Rear Engine Rider will 
stop within 5 feet from fastest speed.  If stopping 
distance is more than 5 feet, the wheel brake should 
be adjusted as follows: 
1.  Follow WARNING statement found on this page. 
2.  Check fuel level in tank.  If over 3/4 full, remove 
tank. Refer to Section “REMOVING FUEL TANK”.  If 
3/4 or less, proceed to next step.  
3.  Carefully stand Rear Engine Rider on rear bumper. 
4. Depress clutch/brake pedal all the way down.  
Move and hold the park brake latch over in the 
“ON” position and release the clutch/brake pedal to 
lock the park brake. See Figure 4.7. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

FIGURE 4.7 

 

5. 

Measure the distance between end of 

clutch/brake cable and bottom of housing. 

 

Measurement should be no less than 1/2” and no 
greater than 3/4”.  See Figure 4.8. 
6.  If measurement is less than 1/2” or greater than 
3/4”, loosen the two jam-nuts. See Figure 4.9. Hold 
the clutch/brake cable to the chain case bracket.  
7. Adjust cable up or down using the jam-nuts to 
obtain a distance of 1/2” to 3/4” between end of 
clutch/brake cable (adjustment shown in inset of 
Figure 4.8) and bottom of housing. See Figure 4.9. 
8. After adjustment is complete, securely tighten 
cable jam-nuts.