Snapper E331523KVE Manuale Utente

 

 

(Side-To-Side Levelness) 

Before making deck leveling adjustments, check 
the tire pressure. Front tires 12 PSI, rear tires 12 
PSI. If tires are properly inflated and mowing is still 
uneven, adjust side-to-side deck levelness. 
1.  Place Rider on a smooth level surface. 
2.  Follow WARNING statement found on this page. 
3. Place a piece of angle iron, pipe, or similar 
object under center of deck at the rear. 
4. Remove rear hanger chains and allow center, 
rear of deck to rest on angle iron. 
5.  Measure the distance from blade tips to floor. If the 
measurement is within 1/8” from side-to-side, the deck 
attitude is satisfactory.  If difference from side-to-side is 
greater than 1/8”, continue with adjustment. 
6.  Loosen the shoulder bolt and nut retaining the left 
side of the front lift arm and adjuster. Only loosen the 
bolt and nut to the point where some tension remains 
but lift arm can be moved. See Figure 4.5. 
7.  Move lift arm up or down as required until blade tips 
are within 1/8” of each other.  See Figure 4.6. 
8. Tighten shoulder bolt & nut loosened in Step 6. 
Recheck both sides of deck for correct levelness. 
9. Readjust rear hanger chain pivots to align with 
holes in support brackets. See Figure 4.6. 
10.  Remove angle iron, pipe, or similar object and 
proceed to check front to rear levelness. 

With the Rear Engine Rider on a smooth, level 
surface, rotate blade until blade tips are at front and 
rear of deck.  Measure the distance from blade tips 
to floor. The distance should be the same, or the 
rear 1/8” to 1/4” lower than the front. If the rear 
blade tip is higher or is more than 1/4” lower than 
the front, proceed with adjustment. Go to Step 1. 
 

With the Rear Engine Rider on a smooth, level 
surface, rotate blade until blade tips are at front and 
rear of deck. Measure the distance from blade tips to 
floor. The distance should be the same, or the rear 
1/8” to 1/4” higher than the front.  If the rear blade tip is 
lower or is more than 1/4” higher than the front, 
proceed with adjustment. Go to Step 1. 
1.  Remove rear hanger chains. 
 

2. Turn each hanger pivot the same number of 
rotations on the eye-bolt to raise or lower the rear of 
the deck.  See Figure 4.6. 
3.  Reinstall rear hanger chains and measure blade 
tips again. 
4. Repeat steps “1” through "3” until proper 
levelness is obtained.