Epson FX-1180 Descrizione Prodotto

EPSON FX-880/FX-1180

10 -

 

EPSON FX-880/FX-1180

11/98

2. Tear off the printed document at the perforation using the 

tear-off edge of the printer cover. (Pull it toward you for a 
clean cut.)

3. Press the 

Load/Eject

 button to feed the continuous paper 

backward out of the printer and into the standby position.

Caution:
Always tear off your printed document before you 
press the Load/Eject button. Reverse feeding several 
pages at a time may cause a paper jam.

1. Tear off the fresh supply of continuous labels at the 

perforation nearest the paper entry slot.

2. Hold down the 

LF/FF

 button to eject the remaining labels 

from the printer.

Caution:
Never press the Load/Eject or Tear Off/Bin button 
when printing on labels. When fed backward, labels 
can easily come off the backing sheet and cause a 
jam.

You can easily switch from printing on continuous paper with 
a push tractor to printing on single sheets without having to 
remove or reload paper. Follow the steps below.

Note:

❏

If continuous paper with labels is loaded in the printer, remove it 
before switching to single-sheet printing. 

❏

If the tractor is in the pull position, remove any continuous paper 
from it before switching to single-sheet printing. 

1. If any printed pages of continuous paper remain in the 

printer, press the 

Tear Off/Bin

 button to advance them to 

the tear-off position, and then tear them off.

Caution:
Tear off your printed document before you press the 
Load/Eject button in the next step. Reverse feeding 
several pages at a time may cause a paper jam.

Never use the knob to eject paper while the printer is 
on; this may damage the printer or cause it to lose the 
tear-off or top-of-form position.

2. Press the 

Load/Eject

 button to feed the continuous paper 

backward to the standby position. 

3. Lower the continuous paper support on the paper guide 

until it clicks into place, then move the paper guide to the 
upright position.

4. Load single sheets in the printer.

5. Set the paper release lever to the single-sheet position.

To switch from printing on single sheets to printing on 
continuous paper with the front or rear push tractor, follow 
the steps below.

Note:
To switch from printing with the optional front sheet guide to printing 
with the front push tractor, you need to remove the front sheet guide.

1. If a single sheet remains in the printer, press the 

Load/Eject

 

button to eject it.

Caution:
Never use the knob to eject paper while the printer is 
on; this may damage the printer or cause it to lose the 
tear-off or top-of-form position.

2. Make sure that the tractor is installed in the front or rear 

push position and that continuous paper is loaded on the 
tractor.

3. Set the paper release lever to the appropriate position.

tear here