Epson FX-1180 Descrizione Prodotto

EPSON FX-880/FX-1180

12 -

 

EPSON FX-880/FX-1180

11/98

Note:
Your tear-off position setting remains in effect until you change it, 
even if you turn off the printer.

1. Make sure the 

Tear Off/Bin

 light is flashing (the paper is at 

the current tear-off position). You may need to press the 

Tear Off/Bin

 button.

2. Hold down the 

Pause

 button for about three seconds. The 

Pause

 light begins flashing and the printer enters the micro 

adjust mode.

3. Press the 

Load/Eject

 

 

U 

and 

LF/FF

 

 

D

 buttons to feed the 

paper backward or forward until the paper perforation is 
aligned with the tear-off edge of the printer cover.

Note:
The printer has a minimum and a maximum tear-off position. If 
you try to adjust the tear-off position beyond these limits, the 
printer beeps and stops moving the paper.

4. Press the 

Pause

 button to turn off micro adjust mode. 

Then tear off the printed pages.

When you resume printing, the printer automatically feeds the 
paper back to the top-of-form position and begins printing. 

Warning:
You need to move the print head by hand to install or 
replace the ribbon cartridge. If you just used the 
printer, the print head may be hot; let it cool before 
you replace the ribbon cartridge.

Caution:
Make sure the printer is off and unplugged from the 
electrical outlet. Moving the print head while the 
printer is on may damage the printer.

1. Remove the printer cover.

2. Press up the tabs on the paper tension unit, then lift the 

front of the unit and pull it up and out of the printer.

3. Make sure that the print head is not hot; then slide the print 

head to the middle of the printer by hand.

4. Grasp the used ribbon cartridge by its handle and pull it up 

and out of the printer.

5. Turn the ribbon-tightening knob of the new ribbon 

cartridge in the direction of the arrow to remove any slack 
in the ribbon. 

tear-off edge

paper tension unit

ribbon cartridge

 

handle

print head