Pantech caper Guida Utente

16 

02
03
04
05
06
07

01

1.   Insert your fingernail into the slot(1), then push down on 

top of the battery cover and slide it off to remove (2).

2.   Slide the battery into the slot (3) by aligning the contacts 

and push down (4) until you hear the “click”.

3.   Align the cover tabs with the slots on the back of the 

device and slide the battery cover onto the unit until it 
snaps into place.

   If the battery is not correctly placed in the compartment, the handset will not turn on 

and/or the battery may detach during use.

1.   To remove the battery cover, insert your fingernail into 

the slot(1), then push down on top of the battery cover 
and slide it off (2).

2.   Insert your fingernail into the slot (3) and lift the battery 

from the compartment (4). 

3.   Align the cover tabs with the slots on the back of the 

device and slide the battery cover onto the unit until it 
snaps into place.

1.    To Charge, connect the wall charger. Make sure you 

align the connector as shown in the image.

2.    Plug the wall charger into an electrical outlet.

   If the battery connector is not properly aligned, damage 

could occur to the charging connector and the phone may 
not charge.