Alcatel-Lucent 6850-48 Guida Di Rete

Modifying IPMSv6 Parameters

Configuring IP Multicast Switching

page 42-32

OmniSwitch AOS Release 6 Network Configuration Guide

You can modify the source timeout from 1 to 65535 seconds by entering 

followed by the new value. For example, to set the source timeout to 360 seconds on the system if no 
VLAN is specified, you would enter:

-> ipv6 multicast source-timeout 60

You can also modify the source timeout on the specified VLAN by entering:

-> ipv6 multicast vlan 2 source-timeout 60

To restore the source timeout to its default (i.e., 30 seconds) value on the system if no VLAN is specified, 
use the 

 command by entering:

-> ipv6 multicast source-timeout 0

Or, as an alternative, enter:

-> ipv6 multicast source-timeout

To restore the source timeout to its default value.

You can also restore the source timeout on the specified VLAN by entering:

-> ipv6 multicast vlan 2 source-timeout 0

Or, as an alternative, enter:

-> ipv6 multicast vlan 2 source-timeout

To restore the source timeout to its default value.

By default MLD querying is disabled.The following subsections describe how to enable and disable MLD 
querying by using the 

command.

You can enable the MLD querying by entering 

 followed by the enable keyword. 

For example, to enable the MLD querying you would enter:

-> ipv6 multicast querying enable

You can also enable the MLD querying on the specified VLAN by entering:

-> ipv6 multicast vlan 2 querying enable

You can disable the MLD querying by entering 

 followed by the disable 

keyword. For example, to disable the MLD querying you would enter:

-> ipv6 multicast querying 

disable